New Page 1

HDH Winder Machine

Features

Wires from the finest, to as heavy as number 4 AWG, are handled with equal ease with the two speed ranges and the infinitely variable SCR drive.
The operator will soon appreciate the many convenient features. The large digital display electronic counter is easily read
and can be switched to count up to a preset count regardless of which direction the spindle is set to turn. In either mode,
if the operator backs off a turn, the counter will subtract that turn. The traverse end stops are also adjustable for fine adjustments of traverse length.
All controls are on the front panel within convenient reach of the operator. There are no back gears to engage for low speed and high torque.
The coil can be wound in high speed range to within a few turns of Finish, switch to low speed with plenty of torque
and control for stopping accurately, or for inching to the proper position under full and controlled power.
When the operator's foot is off the pedal, the spindle is locked automatically or left free at the operator's choice.
On the face of the machine is an Amp Meter which enables the operator to occasionally monitor the current being pulled by the motor.
The optional variable speed traverse mechanism is a popular option. It is variable from zero to 3/16 of an inch per revolution.
Two adjustable traverse speeds can be preset, so that they can be switched instantly from one to the other when winding a primary and secondary with different size wires.
The tail stock is a rugged toggle action type for quick loading and unloading of winding forms and can be equipped
with a 60-degree center, or live center, or ball bearing disc which can be modified for holding any kind of shape.

Specifications

WIRE SIZES: From #4 to the finest.
COIL SIZES: 14" Diameter maximum with tail stock; 12" Diameter with traverse mechanism.
COIL LENGTH: 12" with 40" bars (tip of Jacobs Chuck to live center of tail stock). Additional lengths available.
SPEED RANGE: Up to 0-1350 RPM high, and up to 0-260 RPM low speed.
SPEED CONTROL: Infinitely variable by foot control.
WIRE LAYERING: By hand or with optional front or rear traverse guide.
SPINDLES: Rugged 1" Diameter spindle shaft with 1/2" hole.
MOTOR: 1 HP permanent magnet DC motor, 1725 RPM.
COUNTER: Electronic counter counts 1/10 turns, add-subtract type.
POWER: 115V A.C.
DIMENSIONS: 16" high x 24" deep x 24" wide without tail stock.
STANDARD LENGTH OF MACHINE: Is 40" with tail stock using 40" bars, giving up to 12" between chuck and tail stock.
WEIGHT: 115 lbs. without tail stock.